The short version
- Top, bottom and outside margins: at least 0.25 in (6.4 mm) for books without bleed, 0.375 in (9.6 mm) for books with bleed.
- Inside margin (gutter): depends on the page count, from 0.375 in up to 0.875 in (table below).
- Page numbers and running heads count as content: they must sit inside these margins too.
- These are minimums KDP will accept, not what looks good. See “Going beyond the minimum”.
Inside margin by page count
| Pages | Minimum inside margin |
|---|---|
| 24–150 | 0.375 in (9.6 mm) |
| 151–300 | 0.5 in (12.7 mm) |
| 301–500 | 0.625 in (15.9 mm) |
| 501–700 | 0.75 in (19.1 mm) |
| 701–828 | 0.875 in (22.3 mm) |
Why it grows: a thicker book doesn’t open flat. The more pages, the more of the page near the spine curves into the binding and becomes hard to read, so KDP asks for a wider inside margin.
Which page count? The final page count of your interior PDF, blank pages included. Check it after the last edit, not before: adding a chapter can move you into the next band. KDP prints an even number of pages and rounds an odd count up.
Bleed or no bleed?
If anything (an image, a background colour) runs to the edge of the page, your file needs bleed: add 0.125 in to the outside edges (not to the gutter side), so a 6 × 9 in book becomes 6.125 × 9.25 in, and the outside, top and bottom margins become 0.375 in. If nothing touches the edge, as in most novels and plain non-fiction, you don’t need bleed.
Going beyond the minimum
KDP’s numbers are the lowest it will print. For a typical 6 × 9 novel or non-fiction book, our suggestion (not a KDP rule) is:
- Top and bottom: about 0.75 in.
- Outside: 0.6–0.75 in.
- Inside: KDP’s minimum plus 0.125–0.25 in, so the text doesn’t disappear into the spine on a thick book.
The reason is practical: with only the minimum, text sits close to the trim edge and to the spine, and a small shift in printing and cutting is visible. You can’t judge this on screen. Order a proof copy.
Setting it in Word
- Layout → Size → More Paper Sizes: set the page size to your trim size exactly (6 × 9 in, or 6.125 × 9.25 in with bleed).
- Layout → Margins → Custom Margins. Under Pages, set Multiple pages to Mirror margins.
- Put the whole inside margin in “Inside”. Leave Word’s separate “Gutter” field at 0. If you fill both, you get a gutter twice as wide as you meant, the most common cause of a book that looks off-centre.
- Set top, bottom and outside, and apply to the whole document.
- Check headers, footers and page numbers: they need to be inside the margins too.
These steps are for Word 365; older versions name the menus slightly differently. If you split a long book into several Word files, give every file the same page size, margins and mirror setting, and make the page numbering of each continue from the previous one. Otherwise the merged PDF restarts at page 1 and chapters can end up on the wrong side of the spread.
Check before you upload
- Page count of the final PDF, and the matching row in the table above.
- Page size equals the trim size you chose in KDP.
- KDP’s Print Previewer shows no margin warnings.
- A proof copy looks right in your hands: text not too close to the spine, nothing cut off at the edges.
Do it automatically
Our free KDP margin calculator gives the KDP minimum margins for any trim size and page count. If you’d like print-ready files made from your Word manuscript, join the waitlist.